AWM-3
AWM-3
AWM-3

 

  • Type/ Wave Shaper
  • Width/ 16HP
  • Power/ +77mA/-77mA
  • Depth/ -mm

 
The AWM-3 is an all analog, real-time, complex wave-shaping (triple wave-folder) 3-channel mixer module with added features of compression and multiple mix modes including matrix mixes. The combination of multiple access points (outputs of various mixes), wave-folding, and compression allow for an extremely wide array of signal processing, including complex chorus-like sounds.

All three channels are identical and can operate independently. They can also be cascaded (connected in series) to obtain double and triple wave-folding. The compressor at the front-end of each channel allows for not only unique wave-shaping, but the ability to send asymmetrical wave-shaped signals through multiple wave-fold stages while preserving a better managed signal process.

With individual outputs for each channel, a master mix (and master level control), as well as three matrix mix outputs as: “MIX 1+2” (1 OUT + 2 OUT), “MIX 2+3” (2 OUT + 3 OUT), “MIX 1+3” (1 OUT + 3 OUT), the AWM-3 is wave-shaper, signal processor, and multi-mode mixer.

Each channel has independent positive and negative control over wave-shaping, including CV inputs, CV attenuation, bias (wave-fold threshold), and level (wave-fold volume). Each channel also has a dry level control. Between the dry level, positive wave-fold level, and negative wave-fold level controls, many variations of wave-shaping are possible.
 
Download the AWM-3 manual HERE
 


 
This product is being manufactured or shortly avalilable in overseas.
Shipping in 14-28 days. Contact for more info
Contact

305,00  Add to cart
VCF-74
VCF-74
VCF-74

 

  • Type/ Filter
  • Width/ 14HP
  • Power/ +38mA/-44mA
  • Depth/ -mm

 
The VCF-74 is a 14HP voltage controlled filter in Eurorack format. VCF-74 features a dual analogue high-pass and low-pass filter, cascaded (series, from HP > LP). The discrete diode filter circuit is inspired by the 1970s Univox Mini-Korg synthesizer's “Traveler” filter section which provides warm, organic sound to your modular system. However, this design was not only adapted for Eurorack, but is feature enhanced for a wide array of possible filter characteristics.

A stage boost switch allows you to drive the 2nd filter section (Low-Pass) with a +5.3dB signal boost from the High-Pass output signal creating a warm saturation and varied resonance to signal ratio/dynamics. Independent manual resonance controls per filter section allows you to fine-tune a wide variety of focused sound. Input and Output level controls allow you to optimize dynamic range, including how hard you drive the filter–which drastically changes the dynamic interplay between signal and harmonic resonance. Both High-Pass and Low-Pass circuits have independent cutoff controls. Independent CV inputs for cutoff and resonance of each filter section, and attenuation/gain for CV to cutoff provide superior control over filter behavior. The VCF-74 can be set up as a Low-Pass, High-Pass, or Band-Pass filter. Width of the Band-Pass can be adjusted by simply dialing in the offset controls appropriately.
 
Download the VCF-74 manual HERE
 


 
This product is being manufactured or shortly avalilable in overseas.
Shipping in 14-28 days. Contact for more info
Contact

275,00  Add to cart